EasyManuals Logo

Ezviz H3c User Manual

Ezviz H3c
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
5
2. Installation Location
Choose a location with a clear, unblocked eld of view and with a good wireless
signal.
Make sure that the wall is strong enough to withstand three times the weight
of the camera.
Camera cannot be installed with the lens facing direct sunlight.
3. Installation Procedure
1. Remove protective lm from the lens.
2. Stick the drilling template onto a clean and at surface.
3. (For cement wall only) Drill screw holes according to the template, and insert
anchors.
4. Use screws (PA4×25) to x the camera on the installation surface.
5. Loosen the adjusting screw.
6. Rotate the upper part of the camera to get an appropriate detection effect.
7. Tighten the adjusting screw again.
Drilling Template
Anchor
Camera
Adjusting Screw
Screw
Make sure that the micro SD card slot is facing downward.
0~360°
0~90°

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ezviz H3c and is the answer not in the manual?

Ezviz H3c Specifications

General IconGeneral
TypeIP security camera
Virtual assistantAmazon Alexa & Google Assistant
Placement supportedOutdoor
Connectivity technologyWired & Wireless
Wide Dynamic Range (WDR)Yes
Sensor typeCMOS
Optical sensor size1/2.7 \
Minimum illumination0.01 lx
LED typeIR
Night vision distance30 m
Lens diameter4 mm
Number of lenses1
Total megapixels- MP
Maximum resolution1920 x 1080 pixels
Supported video modes1080p
Video formats supportedH.264, H.265
Noise reduction technology3D noise reduction
BluetoothNo
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Channel bandwidth20 MHz
Wi-Fi data rate (max)144 Mbit/s
Ethernet interface typeFast Ethernet
Security algorithms64-bit WEP, 128-bit WEP, WPA, WPA-PSK, WPA2, WPA2-PSK
Intelligent Video Surveillance (IVS) system featuresHuman detection
Form factorBullet
Mounting typeWall
Product colorWhite
International Protection (IP) codeIP67
Operating temperature (T-T)-30 - 50 °C
Operating relative humidity (H-H)0 - 95 %
Compatible memory cardsMicroSD (TransFlash)
Maximum memory card size512 GB
Power source typeDC
Power consumption (max)6 W
Sustainability certificatesCE, Federal Communications Commission (FCC), REACH, RoHS, UKCA, WEEE
Weight and Dimensions IconWeight and Dimensions
Length157 mm
Weight250 g
Diameter72 mm
Package depth100 mm
Package width227 mm
Package height92 mm
Package weight447 g

Related product manuals