F.W. Bell 8000 series User Manual

F.W. BELL 8000 Series Gauss/Tesla Meter Instruction Manual
Section 8 – Remote Operation 8-12
Configuration
The only gaussmeter setting that may be configured for the GPIB
communications is the instrument address. This may be any value between 0
and 30.
Navigating the system menu from [Main] to [System
⇒ Comm Setup ⇒ GPIB
Configuration] will bring up the GPIP configuration screen as shown below.
Use the hot keys to set the desired address.
Figure 8-8 GPIB Configuration Screen
Note: The Prologix GPIB-USB Controller will be set by the meter to this
address.

F.W. Bell 8000 series Specifications

General

Brand	F.W. Bell
Model	8000 series
Category	Measuring Instruments
Language	English