6
402 OPERATOR
D
E
AC Line
The self contained 402 operator is an electro-hydraulic unit
consisting of an electric motor, a pump, a valve assembly and
a hydraulic cylinder, all housed in an anodized aluminum oil
reservoir.
All models of the 402 operator have one hydraulic lock. The
CBC version is designed to lock when the piston is extended. The
optional CBA version is designed to lock when the
piston is retracted.
The hydraulic lock is a service device rather than a security de-
vice. Additional external locks are recommended if tight security
is needed.
The 402 operator is designed and built to automate vehicular
swing leaf gates. Do not use for any other purpose.
Tab. 1: Technical specifications
1.1. DIMENSIONS
1.2. WIRING
Fig. 1
Front bracket
Housing
Rear bracket
Electric motor
Hydraulic piston
Cylinder
By-pass valves
Pump unit
Operators mod. 402
Photocells
Electronic control unit
Key operated push-button
Radio receiver
Warning light
Electric lock (if necessary)
Always separate the connection cables of the low voltage
accessories from the high voltage power cables. Use separate
conduits to avoid interference.
The installer is responsible for grounding the gate and operator
systems, for providing the main power breaker switch, and for
making sure that the entire gate system meets all applicable
electrical codes.
Make sure to locate all controls that operate the gate system
at least 6 ft away from any moving parts.
Fig. 3
Fig. 2
1. DESCRIPTION AND TECHNICAL SPECIFICATIONS
Input voltage 115Vac (+10% -6%) or
230Vac (+6% -10%)
Rod extension speed 0.5 in/sec (1.3 cm/s)
1 l/min
Traction and thrust force 1124 lbf (500 daN)
Operating ambient temperature
4°F +131°F (-20 °C +55°C)
220 W
Current 2A (115V) - 1A (230V)
Motor rotation speed 1400 rpm
Thermal protection 120°C
Weight 14.2 lb (6.5 kg)
Type of oil FAAC HP OIL
Protection class IP 55
10 ft (3m)
900 lb (410 Kg)
Use frequency 55 (cycles/hour)
A
B
C
D
E
To Next Page
Loading...
