Need help?Do you have a question about the FAAC 410 MPS and is the answer not in the manual?
General| Brand | FAAC |
|---|---|
| Model | 410 MPS |
| Category | Control Unit |
| Language | English |
Essential safety rules and warnings for installers to ensure safe operation and prevent damage.
Diagrams and explanations of the control unit's physical layout and electrical connections.
Illustrations of photocell connections for gate safety (opening, closing, combined).
Wiring diagram for the control unit without any safety devices.
Wiring example for pneumatic edges as safety devices.
Wiring diagram for connecting a pair of closing photocells.
Wiring diagram for connecting a pair of opening photocells.
Wiring diagram for connecting both opening and closing photocells.
Wiring diagram for the control unit without safety devices, fail-safe disabled.
Wiring for pneumatic edges, fail-safe disabled.
Wiring for closing photocells, fail-safe disabled.
Wiring for opening photocells, fail-safe disabled.
Wiring for two pairs of closing photocells, fail-safe disabled.
Wiring for closing and opening/closing photocells, fail-safe disabled.
Details on connecting STOP devices and configuring the STOP input.
Configuration for N.O. contacts for two-leaf opening/closing devices.
Connection for photocell transmitter power supply, including Fail-Safe.
Adjusts anti-crushing safety torque for electromechanical operators.
Adjusts pause time for automatic and safety logics.
Adjusts the gate opening and closing operation times.
Adjusts the delay time for the second leaf closing.
Settings for operating logic and safety functions via microswitches.
Details of the four available operating logics: Automatic, Safety, Semi-Automatic, Auto Timer.
Selection of closing safety modes: immediate reverse or stop and reverse.
Explanation of the status and meaning of the control unit's LED indicators.
Procedure to correctly set the motor's direction of rotation for gate operation.
How to adjust the gate opening and closing times using the OP/CL trimmer.
Setting the delay for the second leaf to close, for overlapping leaves.
Adjusting the momentary stop time between gate movements.
Adjusting the torque control for anti-crushing safety on operators.
To Next Page
