Fig.01
Fig.02
These instructions apply to the following models:
FAAC 740 - 741
The 740-741 gearmotor is an electro-mechanical operator designed
for moving sliding gates.
The non-reversing reduction system ensures the gate is mechani
-
cally locked when the gearmotor is not operating, therefore it is
not necessary to install any electric lock
AUTOMATED SYSTEM 740-741
A convenient manual release with customised key makes it possible
to move the gate in the event of a power failure or malfunction
of the operator.
The 740-741 gearmotor was designed and built for controlling
vehicle access. AVOID ANY OTHER USE WHATEVER.
1. DESCRIPTION AND TECHNICAL SPECIFICATIONS
2. DIMENSIONS
MODEL 740 741 740 115V 741 115V
Power supply (+6% -10%) 230 V~ 50Hz 230 V~ 50Hz 115 V~ 60Hz 115 V~ 60Hz
Absorbed power (W)
350 500 350 600
Absorbed current (A)
1.5 2.2 3 5.2
Capacitor (µF)
10 12.5 30 50
Thrust on pinion (daN)
45 65 45 65
Torque (Nm)
18 24 18 24
Winding thermal protection (°C)
140 140 140 140
Leaf max weight (Kg)
500 900 500 900
Type of pinion
Z16 Z16 Z16 Z16
Gate speed (m/min)
12 12 14 14
Gate max length (m)
15 15 15 15
Type of limit switch
Magnetic Magnetic Magnetic Magnetic
Clutch Electronic Electronic Electronic Electronic
Use frequency S3 - 30% S3 - 40% S3 - 30% S3 - 40%
Operating temperature (°C) -20 +55 -20 +55 -20 +55 -20 +55
Gearmotor weight (Kg)
10 11 10 11
Protection class
IP44 IP44 IP44 IP44
Gearmotor overall dimensions See Fig.02 See Fig.02 See Fig.02 See Fig.02
1. Motor lid
2. Electronic control unit
3. Release device
4. Gearmotor body
5. Foundation plate
6. Pinion
7. Limit switch
8. Motor cover
9. Cable holes
10. Capacitor
11. Protective side panels
Values are expressed in mm
To Next Page
Loading...
