Facina_VKPCCTV_Instructions_Rev01
23
•
To change the resolution and burst number, please follow
the
Setting the Programmable mode & Setting the Image
Resolution in PIR mode & Setting the Burst Shoot in PIR mode.
EXAMPLE:
#1: If a user selected the Time Lapse Mode (TLS), and sets the
Start Time to 07:00 and End Time at 20:30, then selects the
Timeout to be 3 mins with a Burst mode of 3 pictures, this means
that the camera will keep taking 3 pictures for every 3 minutes
within the time frame of 7:00AM to 8:30PM. When not within
the Time Lapse time frame, the camera will follow the normal
PIR detection settings.
#2: If a user selected the Time Lapse mode setting as Start Time
08:00 and End Time 18:00, then selected the Timeout to be OFF
with a Burst mode of 3 pictures, this means the camera will not
take the pictures within the time frame of 08:00 to 18:00.
#3: If a user selected the Time Lapse mode setting as Start Time
00:00 and End Time 00:00, then selected the Timeout to be 5
minutes with a Burst mode of 3 pictures, this means the camera
will keep taking 3 pictures for every 5 minutes, 24 hours a day
non-stop.
Time Lapse Mode Setup Recommendations:
We recommend that if you are using the Time Lapse feature and
want to extend your battery life and get the most pictures
possible, pls use the following settings:
Batteries: Energizer Lithium Batteries
Resolution: Basic (1 Star–2MP)
Time Out: More than 30 seconds
To Next Page
Loading...