Faema E92 - Cup-Warmer; Switching on - Electric; Switching on - Gas (Only for G Machines)

EnglishEnglish
50
1. Switching on – electric
“Before switching on the machine, ensure the
following:
The mains switch is on.
The water mains tap is open”.
Press the master switch (1); the indicator light “machine on”
(2) switches on.
At the same time, the current working pressure “boiler
pressure 0.00 bar” is displayed (14).
If the water level in the boiler is less than the minimum
required, the indicator light “boiler level” (4) lights up and the
boiler is filled up to the correct level (indicator light 4 switches
off).
Press the master switch (1a) to position 2.
The heating element inserted indicator light (3) lights up.
The boiler is heating. Wait until the pressure reading on the
display corresponds to the required working pressure value,
i.e. the indicator light (3) switches off.
!!
!!
!
CHARACTERISTICS
- Roomy cup-heating shelf
- Choice of several heating temperatures
Arrange the cups on the shelf. Best results are obtained
when NOT MORE than three layers of cups are put on the
shelf.
2. Cup-Warmer
!!
!!
!
CAUTION: do not put any cloth on the cup-warmer.
1241a 3 6
“Do not switch on the gas when the boiler is under
pressure”.
Before switching on the machine. check the following:
- The mains switch is on.
- The water mains tap is open.
- The gas cut-off cock is open
Press the mains switch (1) to position 1, the indicator light
“machine on” (2) lights up.
At the same time, the current working pressure “boiler
pressure 0.00 bar” is displayed (14).
If the water level in the boiler is less than the minimum
required, the indicator light “boiler level” (4) lights up and the
boiler is filled up to the correct level (indicator light 4 switches
off).
Press and rotate the knob of tap (24) towards the left to
position B, and keep pressed for about 30 seconds. Check
that window (23) is open and after a few seconds release
knob (24).
The boiler is heating up. Wait until the indication on the display
(14) corresponds to the pressure value required.
3. Switching on – gas (only for G machines)
!!
!!
!
24 421
B
To change the cup-warmer power, press the key (6) a number
of times.
- All LEDS on = full power
- All LEDS off = OFF
When the machine is turned off after the day’s operations,
the selections will remain in the machine’s memory.