Faema E92 - Programming the Hot Water Distribution Keys

EnglishEnglish
65
3.4 Programming the hot water distribution keys
Press one of the hot water distribution keys (13a - 13c). The
related LED remains on and does not blink. The display
appears as follows:
The following hot water selection parameters can be
modified:
- water dispensing time (from 0 to 60, with increments of
0.1 seconds).
Programming measures using the “SELF-LEARNING”
function
To memorize the programming of the hot water dose, follow
the procedure herebelow:
1) Place a container by the hot water distribution nozzle (10).
2) Press the PROG (32) key; the following message will
appear on the display:
3) Keep the distributor key pressed, as evidenced by the
flashing led (the hot water dose counter starts from zero
and increases in value).
selection XXX
dispens. time 05.0s
+
u
u
selection XXX
dispens. time 05.0s
+
u
u
10
13c
13b
13a
selection XXX
dispens. time 05.0s
+
u
u
ÆÆ
ÆÆ
Æ
4) When the quantity of water in the container has reached
the desired level, release the key (the counter will indicate
the time that corresponds to the set dose).
It is possible to vary the set dose via the “+” (34) and “-” (35)
keys (the time of the water distribution can also be increased
or decreased).
When the key
444444
444444
444 (33) is pressed, the following message
is again displayed: