40
INSTALLATION
Adjust the valves
To adjust the valves turn the burner knob to
"economic ame" position and ignite the ame.
In order to check the ame, heat up the burner
on a full ame for about 10 min., and then
turn the burner knob to an economic ame
position. The ame should not go out or jump
on the nozzle. However, if it does, readjust of
the valves.
Conversion of the appliance to a
dierent gas type than specied by
the manufacturer on the nameplate
or purchasing an appliance that is
intended for a dierent gas type than
provided in the building, is entirely
up to the user and installer.
For COPRECI valves, remove the hob and
adjust the size of an economic ame with a
screwdriver.
To Next Page
Loading...
