Quick reference
16
(SOFT 03.1X)
G83. Deep-hole drilling canned cycle with constant peck
G83 Z I J B K
Z Reference plane.
I Drilling peck (step).
J Number of pecks required by the drilling operation.
B
Rapid withdraw (G00) distance after each drilling
step.
K Dwell, in seconds, at the bottom of the hole.
G84. Tapping canned cycle
G84 Z I K R
Z Reference plane.
I Tap depth.
K
Delay, in seconds, between the tapping and the
withdrawal movement.
R Type of tapping.
• "R"=0: normal tapping.
• "R"=1: rigid tapping.
G85. Reaming canned cycle
G85 Z I K
Z Reference plane.
I Reaming depth.
K
Delay, in seconds, between the reaming and the
withdrawal movement.
Z
I
Zi
G90 G91
Z
Zi
G90 G91
Z
I
Z
I
G90
Z
I
Zi
Z
I
G91
To Next Page
Loading...
