Quick reference
19
(SOFT 03.1X)
G69. Stock removal canned cycle along Z axis
G69 X Z C D L M K F H S E P
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
C Machining pass.
D Distance to withdraw the tool after each pass.
L Finishing stock in X.
M Finishing stock in Z.
K Penetration feedrate for the roots (valleys).
F Feedrate for the last roughing pass.
H Feedrate for the finishing pass.
S
Label number of the first block describing the
geometry of the profile.
E
Label number of the last block describing the
geometry of the profile.
P
Number of the subroutine where that defines the
profile.
G81. Turning canned cycle with straight sections
G81 X Z Q R C D L M F H
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
Q X coordinate of the profile's last point.
R Z coordinate of the profile's last point.
C Turning pass.
D Safety distance to withdraw the tool after each pass.
L Finishing stock in X.
M Finishing stock in Z.
F Feedrate for the last roughing pass.
H Feedrate for the finishing pass.
G82. Facing canned cycle with straight sections
G82 X Z Q R C D L M F H
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
Q X coordinate of the profile's last point.
R Z coordinate of the profile's last point.
C Turning pass.
D Safety distance to withdraw the tool after each pass.
L Finishing stock in X.
M Finishing stock in Z.
F Feedrate for the last roughing pass.
H Feedrate for the finishing pass.
To Next Page
Loading...
