Quick reference
20
(SOFT 03.1X)
G83. Axial drilling and tapping canned cycle
Axial drilling:
G83 X Z I B D K H C R
Axial tapping:
G83 X Z I B0 D K R
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
I Depth.
B Type of operation to be executed:
• "B"=0: Axial tapping.
• "B">0: Axial drilling.
D Safety distance.
K
Dwell, in hundredths of a second, at the bottom of
the hole before starting the withdrawal.
H
Withdrawal distance in rapid (G00) after each
drilling.
C
Defines the approach distance along Z from the
previous drilling step to start the next drilling step (in
G00).
R In the drilling cycle:
• Factor that reduces the drilling peck (step) "B".
In the tapping cycle:
• Type of threading to be executed.
G84. Turning canned cycle with arcs
G84 X Z Q R C D L M F H I K
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
Q X coordinate of the profile's last point.
R Z coordinate of the profile's last point.
C Turning pass.
D Safety distance to withdraw the tool after each pass.
L Finishing stock in X.
M Finishing stock in Z.
F Feedrate for the last roughing pass.
H Feedrate for the finishing pass.
I
Distance from the starting point to the arc center
along the X axis.
K
Distance from the starting point to the arc center
along the Z axis.
To Next Page
Loading...
