Quick reference
21
(SOFT 03.1X)
G85. Facing canned cycle with arcs
G85 X Z Q R C D L M F H I K
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
Q X coordinate of the profile's last point.
R Z coordinate of the profile's last point.
C Facing pass.
D Safety distance to withdraw the tool after each pass.
L Finishing stock in X.
M Finishing stock in Z.
F Feedrate for the last roughing pass.
H Feedrate for the finishing pass.
I
Distance from the starting point to the arc center
along the X axis.
K
Distance from the starting point to the arc center
along the Z axis.
G86. Longitudinal threading canned cycle
G86 X Z Q R K I B E D L C J A W
X X coordinate of the thread's starting point.
Z Z coordinate of the thread's starting point.
Q X coordinate of the thread's end point.
R Z coordinate of the thread's end point.
K
Z coordinate of the point where the thread is to be
measured.
I Thread depth.
B Depth of the threading passes.
• "B">0: Penetration along the X axis:
• "B"<0: Penetration along the X axis:
• "B"=0: It displays the relevant error message.
E
Minimum value that the penetration pass can reach
when "B">0.
D
Safety distance. It indicates at what distance from
the thread's starting point the tool is positioned in
the X axis approach movement.
L Finishing stock.
C Thread pitch.
J Exit from the thread.
A
Tool penetration angle referred to the X axis.
W Optional parameter. Depends on "K".
BB 2B 3B 4… Bn,,,,,
B2B3B4B… nB,,,,,
To Next Page
Loading...
