Quick reference
22
(SOFT 03.1X)
G87. Face threading canned cycle
G87 X Z Q R K I B E D L C J A W
B Depth of the threading passes.
• "B">0: Penetration along the Z axis:
• "B"<0: Penetration along the Z axis:
• "B"=0: It displays the relevant error message.
E
Minimum value that the penetration pass can reach
when "B">0.
D
Safety distance. It indicates at what distance from
the thread's starting point the tool is positioned in
the Z axis approach movement.
X X coordinate of the thread's starting point. L Finishing stock.
Z Z coordinate of the thread's starting point. C Thread pitch.
Q X coordinate of the thread's end point. J Exit from the thread.
R Z coordinate of the thread's end point. A Tool penetration angle referred to the X axis.
K
X coordinate of the point where the thread is to be
measured.
W Optional parameter. Depends on "K".
I Thread depth.
G88. Grooving canned cycle along the X axis
G88 X Z Q R C D K
X X coordinate of the groove's starting point.
Z Z coordinate of the groove's starting point.
Q X coordinate of the groove's end point.
R Z coordinate of the groove's end point.
C Grooving pass.
D Safety distance.
K
Dwell, in hundredths of a second, after each
penetration until the withdrawal begins.
G89. Grooving canned cycle along the Z axis
G89 X Z Q R C D K
X X coordinate of the profile's starting point.
Z Z coordinate of the profile's starting point.
Q X coordinate of the profile's last point.
R Z coordinate of the profile's last point.
C Grooving pass defined in radius.
D Safety distance.
K
Dwell, in hundredths of a second, after each
penetration until the withdrawal begins.
BB 2B 3B 4… Bn,,,,,
B2B3B4B… nB,,,,,
To Next Page
Loading...
