Quick reference
23
(SOFT 03.1X)
G160. Drilling / tapping canned cycle on the face of the part
Drilling:
G160 X Z I B Q A J D K H C S R N
Tapping:
G160 X Z I B0 Q A J D S R N
D
Safety distance along the Z axis and indicates how
far from the starting point the tool will approach the
part.
K
Dwell, in hundredths of a second, at the bottom of
the hole before starting the withdrawal.
H
Withdrawal distance in rapid (G00) after each
drilling along the Z axis.
C
Defines the approach distance along Z from the
previous drilling step to start the next drilling step (in
G00).
X X coordinate where the cycle is to be executed.
Z Z coordinate where the cycle is to be executed.
S Live tool turning speed and direction.
I Depth referred to the starting point.
B Type of operation to be executed: R In the drilling cycle:
• B=0: Tapping.
• B>0: Drilling.
• Factor that reduces the drilling peck (step) "B".
In the tapping cycle:
Q Angular position for the spindle to execute the cycle. • Type of threading to be executed.
N Number of the spindle for the live tool.A Angular step between two consecutive operations.
J Number of holes to be drilled or tapped.
G161. Drilling / tapping canned cycle on the side of the part
Drilling
G161 X Z I B Q A J D K H C S R N
Tapping
G161 X Z I B0 Q A J D S R N
J Number of holes to be drilled or tapped.
D
Safety distance along the X axis and indicates how
far from the starting point the tool will approach the
part.
K
Dwell, in hundredths of a second, at the bottom of
the hole before starting the withdrawal.
H
Withdrawal distance in rapid (G00) after each
drilling along the X axis.
C
Defines the approach distance along X from the
previous drilling step to start the next drilling step (in
G00).
X X coordinate where the cycle is to be executed.
Z Z coordinate where the cycle is to be executed.
S Live tool turning speed and direction.
I Depth referred to the starting point.
B Type of operation to be executed: R In the drilling cycle:
• B=0: Tapping.
• B>0: Drilling.
• Factor that reduces the drilling peck (step) "B".
In the tapping cycle:
Q Angular position for the spindle to execute the cycle. • Type of threading to be executed.
N Number of the spindle for the live tool.A Angular step between two consecutive operations.
To Next Page
Loading...
