For installers and professionals
1. Connecting your power wire
Note: For IPH20/25/28/35 model, please open the back panel for power connection. The operation is
the same as above.
2. Wiring diagram
12
① Please use cross screwdriver to take off
the 2 screws at the bottom of the right side
panel. Take off the lower half of the panel.
② Unscrew the 3 screws on the cover of the
electrical box.
③ Connect the terminals according to the
electrical diagram.
A. For power supply: 230V 50Hz
Distribution Box(Customer prepare)
Power Cord
Swimming Pool Heat Pump Wiring Board
Power Supply
230V 50Hz
Breaker
B. For power supply: 400V 50Hz
Fuse
vivapool.pl
vivapool.pl
vivapool.pl
To Next Page
Loading...
