Clear all active alarms
This function will clear all active alarms on the ECII™ Flex. It will not remove receivers or codes,
but it will make the ECII™ Flex stop calling out an alarm, without an acknowledgment of that
alarm. Any new alarm input made after this will be handled normally.
From keypad:
From phone:
992 #
Change of PIN code
For entering programming mode remotely from a telephone a PIN code is needed. This is de-
fault “1111”, but can be changed by the following:
From keypad:
< old PIN> < new PIN > < new PIN>
From phone:
900 < old PIN > < new PIN >
< new PIN > #
Alarm receivers and alarm codes
Six different alarm receivers can be programmed. Alarm receivers 1 and 2 have separate alarm
codes and receivers 3-6 use the alarm code for receiver 1. If alarm receiver 2 is programmed,
but not alarm code 2; receiver 2 will use alarm code 1 when dialling.
If the alarm receiver is an alarm centre the centre will provide an alarm code. Program the alarm
code to the correct alarm receiver number. If the alarm receiver is a standard telephone or a
mobile choose your own alarm code. There must always be an alarm code programmed in
order for the ECII™ Flex to call the receiver.
Note: Alarm Code 1 is default set to ‘1’.
1. If required, reset to factory settings:
From keypad:
From phone:
990 #
2. Enter phone number for Alarm Receiver 1:
From keypad:
< Telephone number (max 20 digits) >
From phone:
001 < Telephone number (max 20 digits) > #
3. Enter Alarm Code for Receiver 1:
From keypad:
< Alarm Code 1 (max 10 digits) >
From phone:
091 < Alarm Code 1 (max 10 digits) > #
4. Enter phone number for Alarm Receiver 2:
From keypad:
< Telephone number (max 20 digits) >
From phone:
002 < Telephone number (max 20 digits) > #
5. Enter Alarm Code for Receiver 2:
From keypad:
< Alarm code 2 (max 10 digits) >
From phone:
092 < Alarm Code 2 (max 10 digits) > #
For alarm receivers 3 to 6, use the keys:
From keypad:
instead of
under item 4
above.
From phone:
< 003- 006 > < telephone number > #
Note: Do not forget to test the setting by sending a test receiver alarm.
If a telephone number is missing, an error tone will be heard in the loudspeaker when an
162187 Manual FältCom ECII™ Flex Page 16 of 40
To Next Page
Loading...