FältCom ECII Flex - Incoming Calls Management; 6.13.1 Multiple Units on the Line; 6.13.2 Single Unit on the Line

From keypad:
From phone:
 140  < 1 – 9 > #
With two or more ECII™ Flex connected on the same telephone line, one of them is pro-
grammed as the master with number ‘1’. The others are coded with their individual number (2-
9) by replacing the digit with the corresponding digit. Example:
From keypad:
for lift phone 2 in the chain.
From phone:
 140  2 #
It’s important that there is always one unit with number ‘1’. The unit with number ‘1’ will pick-up
the phone and answer the incoming call.
For best sound quality all ECII™ Flex should be connected in parallel. The last ECII™ Flex in
the series is given number ‘1’.
There can be nine ECII™ Flex connected on the same line. But the telephone exchange can
have a limitation on how many devices are supported on one line; contact your local operator
for information on how many devices they support on one line.
See also section Calls to a lift phone for more information on how to call in to the ECII™ Flex.
6.12.2 Single unit on the line
If the ECII™ Flex does not share the line with any other equipment the unit can be set to answer
the call without requiring the selection of the number on the line; i.e. #1 or #2… This function
will See section Calls to a lift phone for further information on call procedure. To activate this
function:
From keypad:
From phone:
 142 #
To go back to default settings program:
From keypad:
From phone:
 140  < 1 > #
6.12.3 Active alarm mode
This alarm mode opens the ECII™ Flex for incoming calls for 6 hours after an alarm call has
been triggered. After this time the lift phone will be closed for incoming calls until a new alarm
is triggered.
To activate the Active alarm mode the following conditions must be fulfilled:
• Active alarm mode function is programmed
• A lift alarm has been called out
The active alarm mode is closed by pressing 5 on the receiving telephone or from the phone
that has called to the ECII™ Flex.
Alarm mode function is activated with:
From keypad:
From phone:
 141 #
Alarm mode function is deactivated with:
From keypad:
162187 Manual FältCom ECII™ Flex Page 23 of 40