FältCom ECII Flex - Technical & Battery Alarm Receiver

From keypad:
From phone:
# 330 #
6.14.2 Battery alarm from a GSM Gateway (art. 202236)
Similar to 6.15.1 above the GSM Gateway (art. 202236) has battery back-up power in case of
power failure in the building. When a battery alarm is generated in the GSM Gateway, it will
signal this to the ECII™ Flex to detect. Please view the GSM Gateway manual for specifica-
tions. When the battery is replaced the ECII™ Flex will send a battery reset alarm after the new
battery has been tested, the same alarm types will be used for battery and battery reset alarms
as above. Battery alarm is default deactivated in the ECII™ Flex.
Activate battery and battery reset alarms from GSM Gateway:
From keypad:
From phone:
 340 #
To return to default setting, disabling battery and battery reset alarms from GSM Gateway:
From keypad:
From phone:
# 340 #
Simplified acknowledgement – 320
Using this function it is possible to simplify the alarm reception procedure when using a standard
telephone as an alarm receiver. When the function is active, all numeric buttons (0-9) on the
phone will acknowledge the alarm and the
 button disconnects the alarm call. Each time any
of the buttons 0-9 is pressed on the telephone the disconnect time-out is reset to 180 seconds.
Only duplex mode is available.
The function is activated with:
From keypad:
From phone:
 320 #
Return to default acknowledgment:
From keypad:
From phone:
# 320 #
Note: If a speech message is used; press any key to stop the message.
Disconnection of acknowledgement – 321
It is possible to completely disconnect the acknowledgement function. This means that the
ECII™ Flex will make only one attempt to reach the Alarm Receiver 1. No further calls will
be made, regardless of result, until the alarm button is pushed again. Each time any of
the buttons 0-9 is pressed on the telephone the disconnect time-out is reset to 180 seconds.
Only duplex mode is available.
To disconnect the call simply hang up or press the
 button to disconnect the alarm call. If the
call is terminated by hanging up the phone the ECII™ Flex may stay connected on the line for
up to 3 minutes from the start of the call. E.g. if the conversation lasted for 1 minute the ECII™
Flex may stay connected for an additional 2 minutes.
The function is activated with:
From keypad:
162187 Manual FältCom ECII™ Flex Page 25 of 40