12 Technical data
Supply voltage: Telephone line
(Single mounted) If line voltage is higher than 25 VDC no external power is
needed. If line voltage is between 25 VDC and 20 VDC an
external power supply is required.
Supply voltage: 4.5 VDC, 1500V isolation DC converter.
(2-9 units on the same line) If several lift phones are connected to the same telephone line
an external power supply is always required for each unit.
Current consumption: At rest: 25-45 uA
Nominal: 12-60 mA
Ext. power supply: 4-16 mA
Indications: Yellow and green LED during alarm
Sound and light indication when programming
Test alarm/routine call: 1 time/day up to once every 30 days (selectable on/off)
Alarm receiver types: Contact your local distributor for information about alarm cen-
tres that can handle the CPC or P100 protocols.
All tone selection telephones, including mobile phones, can
also be used as alarm receivers
Protocol: CPC
P100
Speech exchange: Duplex or simplex
Signalling: DTMF
Calling: Tone selection
Incoming calls: Automatic (selectable on/off)
Casing: Stainless sheet steel 1.5 mm. Vandal proof.
Dimensions HxWxD: 100 x 90 x 19 mm (behind COP)
140 x 127 x 25 mm (with frame)
195 x 127 x 25 mm (with frame and alarm button)
Weight: 187 gram (behind COP)
235 gram (with frame)
310 gram (with frame and alarm button)
162187 Manual FältCom ECII™ Flex Page 39 of 40
To Next Page
Loading...