FältCom ECII Flex - Automatic Connections and Tests; 6.12 Automatic Test Alarm;Routine Call

It is also possible to make the ECII™ Flex call out an additional test alarm/routine call after each
main alarm. To do this, use alternative 1b instead of 1a.
Activation of test alarm/routine call
1 a. Select the required test interval: 1 to 30 days. (Use a number between 1 and 30.)
From keypad:
<Days (1 – 30)>
From phone:
 080  < 1 – 30 > #
If the test alarm/routine call should go to the same receiver as AR1 and use the same
code; no more programming is needed. If it will go to an individual number, continue to
paragraph 2.
To disable test alarms/routine calls (leaves alarm receiver and code intact, but no test
alarms/routine calls will be made until a new interval is programmed):
1 a. From keypad:
From phone:
# 080 #
Activation of test alarm/routine call after main alarm
1 b. Select the required test interval: 1 to 30 days. (Use a number between 1 and 30.)
From keypad:
<Days (1 – 30)>
From phone:
 082  < 1 – 30 > #
If the test alarm/routine call should go to the same receiver as AR1 and use the same
code; no more programming is needed. If it will go to an individual number, continue to
paragraph 2.
Disable:
1 b. From keypad:
From phone:
# 082 #
Change number of call attempts
The number of call attempts are default 10 times, this can be changed to between 1
and 20 attempts.
From keypad:
< 1 – 20 >
From phone:
 085  < 1 – 20 > #
Reset to 10 call attempts:
From keypad:
From phone:
# 085 #
Number for separate test alarm/routine call receiver
2.
Enter the telephone number of the test alarm/routine call receiver:
From keypad:
<Telephone number (max 20 digits)>
From phone:
 300  < telephone number (max 20 digits) > #
3. Enter alarm code for the test alarm/routine call:
From keypad:
<Code (max 10 digits)>
162187 Manual FältCom ECII™ Flex Page 21 of 40