6. Getting started
6.4 Fan control
The fan is controlled by temperature but for safety reason it is running
at maximum speed all the time by default. You can set the fan to be
temperature controlled only by following these steps:
1. Enter stand-by mode. Tuning display shows “---“
2. Press and hold A+B buttons together. Then additionally press
the 2 lower red buttons on the wheel rim.
In the Tuning display you first see the firmware version and then the de-
fault status of the fan (“on” or “off”)
6.3 Calibration
A 6-speed gear stick (7GS) must be calibrated when you connect it the first time.
If the shifter is not working properly it might require new calibration as well.
Please go through the following steps:
1. Power on the wheel
2. Choose any platform mode (PS3/PC). Make sure your shifter is connected to
the wheel.
3. Press “Start Button” + “Tuning Button” at the same time
4. Bring the 7GS into neutral position and press the “Start Button”.
5. Enter reverse gear and press “Start Button”
6. Enter 1st gear and press “Start Button”
7. Enter 2nd gear and press “Start Button”
8. Enter 3rd gear and press “Start Button”
9. Enter 4th gear and press “Start Button”
10. Enter 5th gear and press “Start Button”
11. Enter 6th gear and press “Start Button”
Shifter calibration finished. You can check the proper functionality with use of the
PC driver menu.
6_n
6_r
6_1
6_2
6_3
6_4
6_5
6_6
To Next Page
Loading...
Need help?
General
