Fancom 747 - 6.3 Acceptation Limits Setup

Fancom 747 6. Settings
16
Entering a time clock
1. Press key Clock.
The following text will appear on the display:
2. At Time clock enter the times between which the computer must
register measurements.
3. Clock shows if the computer is currently registering weights
(ACTIVE) or not (NON-ACT.).
6.3 Acceptation limits
Fancom delivers the weighing computer with factory settings. These can
be changed, but it is not strictly necessary.
Method
1. Press key Acceptation settings.
The following text will appear on the display:
2. At Lower limit (%) and Upper limit (%) enter the limits in
percentages, between which the computer must accept
measurements.
Timeclock 0:00-24:00
Clock ACTIVE
Way of meas. ON-OFF
Lower limit(%) 30
Upper limit(%) 30
>>