Fanimation SCULPTAIRE FP8511 Series - Final Light Kit Component Assembly

14
8. Disconnect the 2 single-pin connectors from the
LED assembly to the 2 single-pin connectors from
light plate assembly. (Figure 8)
7. For use with steel cap
Remove the three screws in the LED assembly.
(Figure 7)
6. Secure the light shade to switch housing assembly
by twisting in a clockwise direction.
Do not over-tighten. (Figure 6)
How to Assemble Your Light Kit or Cap (Continued)
Figure 8
Light Plate
Assembly
Switch Housing
Assembly
Light Shade
LED Assembly
LED Assembly
Figure 7
Figure 6
Light Plate
Assembly
9. Assemble the light kit wire cover to the light plate
assembly using the two key slots and tighten with
the supplied screws. (Figure 9)
Figure 9
Light Kit
Wire Cover
Light Plate
Assembly
Figure 10
Steel Cap
Switch Housing
Assembly
10. Assemble the steel cap to the switch housing
assembly by twisting in a clockwise direction.
(Figure 10)