INSTALLATION
070002_3_B
FGP 50/2 EVO-2
7
CORRECT BURNER POSITION
BOILER PLATE
FLAME TUBE LENGTH
Flame tube length must be selected based on the specifications supplied by boiler manufacturer and, in any case, it
must be greater than the thickness of the boiler door included its insulation.
In case of boilers with flame inversion or front flue combustion chambers, it is necessary to insulate the area between
the flame tube and front door with refractory material. This protection material must not impede flame tube extraction.
** For different flame lengths, please contact our Technical-Sales Department.
The burner is designed to work only in the positions as
shown in the picture.
Any other position could compromise the correct working
of the burner.
Crossed positions are forbidden for safety reasons.
Fig. 5 Correct burner position
* Suggested dimension of connection between burner
and generator.
Fig. 6 Boiler plate
MODEL
L min L max M N min N* N max
FGP 50/2 EVO-2 mm 205 226 M10 160 160 180
MODEL
TC TL **
FGP 50/2 EVO-2 mm 250 335
To Next Page
Loading...
