Note:
1. During the test, the object or person between the camera and the target should be
removed to prevent the target from being blocked, and ensure that the ground will not
reflect light which will affect the measurement results.
2. If the target is blocked, the left and right targets should be properly adjusted. The
target must be clearly visible.
3.Before entering the target monitoring, please make sure that the target type and
front position are set correctly. For details, see Chapter 6 System Setting.
4.2 Ground mode
General measurement flow of ground mode：Model selection→ Push compensation
→adjust→ Back tilt measurement→ adjust→ Test drive→ Save measurement data
→View/print results，the operation flow and method of general measurement will be
described below.
4.2.1 Vehicle selection
Select 【 】 on the main interface of the system, the system will automatically
enter the vehicle selection interface. The vehicle selection interface is shown in figure
4.2.1-1:
To Next Page
Loading...
