ST100 Series HART
Fluid Components International LLC 7
Service Data Operation
The Service Data functions are organized into 3 areas:
1. ST100 Basic Setup
2. ST100 Configuration
3. ST100 Factory Calibration Limits
The service information is presented here as seen through the 475 HART communicator, with FCI’s EDDL files loaded. The same information seen by
the 475 is shown in the DCS when the ST100 HART EDDL files are loaded.
ST100 Basic Setup
The Basic Setup function includes the ability to review and change the
engineering units of the process variables, review and change the Plenum or
pipe size, enable or disable the Totalizer, review and change device informa-
tion, reset the operation of the ST100 to the factory settings, enable or disable
the write protect, and PV Setup.
Engineering Units Information
To Next Page
Loading...
