How to display decimal point on FE PXR4?
If a decimal point has not been displayed on your FE Microcontroller, it might be because “0” is set in the parameter . To display the decimal point, set the parameter to “1” or “2”.
Why does the display on my FE Microcontrollers show incorrect values?
If the display on your FE Microcontroller is showing unexpected values, it could be due to several reasons. First, the setting might not be correct for the input signals from sensors. Also, check if the polarity of the sensor matches the PXR; if not, correct it. Input terminals may be short-circuited in thermocouple B or R; in this case, set the parameter to 3 and check the temperature. The input signals of sensors might not match those of your controller, which may require adaptations or a replacement. Ensure the connecting cables for the sensor are tightened. Finally, a break or short-circuit in the sensor, or issues with the sensor or other input devices connected to the PXR, could be the cause; replace the sensor or input devices as needed. Also, verify that the set value of parameter ...
Lists PXR parameters categorized by frequency of use (operation, first block, second block, third block).
Explains basic operations and parameter setting procedures for the PXR controller.
Details the functions of various parameters and provides step-by-step setting examples.
General| Brand | FE |
|---|---|
| Model | PXR4 |
| Category | Microcontrollers |
| Language | English |
To Next Page