important Safety instructions
RECOMMENDED CIRCUIT
WIRE SIZES
(As installed per building code) :
PROTECTORSIZE WIRE GAUGE
15AMP #14 MINIMUM
20AMP #12 MINIMUM
30 AMP #10 MINIMUM
©©
125V 250V
15A 20A
©©
250V 250V
15A 30A
Power Supply:
115V, 60HZ
AC Only 1-Phase
Outlet Requirement:
3-Prong Grounding Type
125V, 15Amp
Minimum Wire Size:
#14 (A.W.G.) 3-Wire
Use CopperWire Only
Circuit Protector:
15 AmpTime Delay Fuse
or
Circuit Breaker
M
C) Three-prong grounding plug.
Do not alter plug end.
(_ Grounded three-prong wall
receptacle
(_) Single outlet grounding wall
receptacle
Electrical Shock
Hazard
• Plug unit only into grounded
electrical outlet.
• Do not use an extension cord or
plug adapter with this unit.
• Do not operate unit with filter
removed.
• Failure to follow these precautions
could result in electrical shock, fire
or personal injury.
• Do not alter cord or plug end. Do
not remove warning label on cord.
Important Grounding _ •
Requirements
Your unit will operate on any 115 •
volt, 3-pronged (grounded), 60 Hz
circuit. A separate line is not
required, but it is advisable not to
overload the circuit with heavy duty •
appliances such as washing
machines, etc.
For your safety, this unit is equipped
with a 3-pronged, grounding plug
and must be plugged into a
properly grounded outlet. If your
outlet is not of the proper type, it is •
your responsibility to have the
outlet and wiring changed to the
correct type. Do not cut off the third
(grounding) prong. Do not use an
adapter.
For Your Safety
Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or any
other appliance.The fumes can
create a fire hazard or explosion.
Do not introduce objects in the
air discharge area.This could
cause permanent damage to your
unit.
Do not pour liquids on the air
conditioner as this could cause a
malfunction. With the unit
unplugged, use a damp cloth for
cleaning your unit.
Avoid using strong solvents to
clean the air conditioner.
Clean the air conditioner filter
every two weeks to avoid
overheating caused by air
obstruction. Be net operate without
filter.
Do not obstruct the air intake
area of your air conditioner, as
this could cause overheating, thus
activating the units security switch
and shutting off the unit.
Do not block air circulation to
exhaust tube, when in use.
De net block air flow inside with
blinds, curtains, or furniture.
To Next Page
Loading...
