FEIN – REPAIR - TOOLS
All rights reserved by FEIN, especially in case of industrial rights registration.
Any power of disposition such as copying and right of transfer is situated with FEIN.
Sahre / MVK 05 / 2011
5. Assembly – Drill jig / Guide
When mounting the gear rod on to the guide, please watch that the locking pin is sitting on the lower end of the guide
(yellow circle). The locking pin is a mechanical stop for the motor, if you are working overhead to the ceiling.
When the guide has to be replaced, please change the locking pin too every time.
Generally the condition of the locking pin has to be checked on every case of repair.(Safety issue)
To Next Page
Loading...
