FeiYu Tech SCORP PRO - 2. Getting Started; 2.1 Charging; 2.2 Install the Tripod

- 3 -
2. Getting started
2.1 Charging
Please fully charge the battery before power on the gimbal for the 󽗉rst time.
Charging with USB2.0 to Type-C cable, supports quick charge.
① Gimbal charging port
Charge for gimbal and handle
② Handle charging port
Handle charging only
1
2
2.2 Install the tripod
Install the 3/8 - 1/4 inch thread insert① with the slot side down on the 1/4 inch screw
which is on the top of the tripod (The thread insert is factory mounted). Mount the
tripod ② to the bottom of the gimbal, then unfold the tripod and place the gimbal
on a 󽗊at surface.
2
1