Page 3
Dear Customer,
Thank you for choosing FELIXprinters! To get your Felix printer up
and running as fast and painlessly as possible please follow this ma-
nual carefully. Please don’t take any shortcuts. It’s better to spend a
few minutes extra on reading, than to wait a week for new parts.
When things are unclear or if you have any remarks or tips, please
contact us at support@FELIXprinters.com. We also recommend
looking on our forum and getting yourself a forum account. You will
benet from the ability to get downloadable and printable upgrades
for your printer. Also it is a great source to obtain and share know-
ledge about your 3D printer and 3D printing in general.
Have fun building!
Kind regards,
FELIXprinters.
Introduction Table of Content
Required tools 5
Chapter 1: Frame 6
Chapter 2: Z-axis 8
Chapter 3: X-axis 11
Chapter 4: Y-axis 15
Chapter 5: Print Head 19
Chapter 6: Wiring 27
Chapter 7: Upload Firmware 31
Chapter 8: Installing LCD 32
Chapter 9: Functional test 33
Chapter 10: Finishing Touch 35
Chapter 11: Checklist 36
Bill of Material 38
To Next Page
Loading...
