Page 32
Download the Firmware:
Download the latest FELIX One Firmware version from:
http://www.felixprinters.com/downloads_felixprinters
Upload the Firmware to the Control Board:
1. Unzip the downloaded le to a convenient location.
(Note: if you click on the zip le from within the Windows explorer, it will NOT be unzipped. You just
view the content of the zip. You need to select the les and drag them to the desired location.)
2. Connect your printer to your computer and turn it on. Do not make a connection at this time with
the printer with programs like Repetier-Host or Simplify3D.
3. Start the batch le “upload_automatic.bat”. A script will start in a command window.
4. The script will try to detect what COM port your printer is using. Check if this is correct, and then
proceed by entering ‘Y’ in the command window.
5. The rmware is uploaded when ‘’Programming nished!’’ is displayed, this may take a few minutes.
6. Press any key to continue. The FELIX One rmware is now successfully uploaded.
Note for Experienced Users: Due to compatibility issues with linux based systems, the baudrate for the
FELIX Tec 4 is lowered to 115200. Make sure to adjust the settings in the used software accordingly.
Chapter 7: Upload Firmware
15 Minutes
To Next Page
Loading...
