Page 36
Check Motor Cable Connections:
IMPORTANT: Keep hand near ON/OFF switch of printer, in case things go wrong.
X-axis motor
To make sure the wires are connected as required it is important to test all connections.
To do so for the x-axis: enter menu by pushing the rottary button --> Control --> Move --> Home X
Y-axis motor
To test the y-axis: enter menu by pushing the rottary button --> Control --> Move --> Home Y
Z-axis motor
NOTE: When doing home z, extruders heatup to 120 DegC to prevent possible lament blobs from scratching the kapton surface layer.
Important: ensure explate is placed on the print bed.
To test the z-axis: enter menu by pushing the rottary button --> Control --> Move --> Home Z
To Next Page
Loading...
