1_Support – Same material as part. This is the best option when printing with support material
which is the same as the printed object. This is the fastest method. The support is printed in such
a way that it is still easy to remove mechanically. The support is only effective when you can
physically reach it with a pliers for instance.
2_Support Soluble. This is the best option when printing with soluble support material like PVA.
The support is printed as close as possible to the object, to obtain the best results. Only suitable
for dual head printing.
3_No Support + Extra Part Adhesion. This option prints no support, but creates a raft on which the printed
object will be printed. This is useful, when you want to print a tall object with a small footprint. This
object can sometimes get knocked over. The raft ensures a solid base.
4_Support – Same material as part + Extra Adhesion. The same as point 3, but with support generation
for the same material as the nozzle.
If in some cases above support strategies are not sufficient, you are able to create your own profile.
Please refer to the full manual for further instructions.
To Next Page
Loading...