FELIXprinters Felix Pro 1 - 10 Print Finished; Remove the 3 D Printed Object

Page | 40
User Manual – FELIX Pro 1
Rev 3
www.FELIXprinters.com
support@FELIXprinters.com
10 PRINT FINISHED
Congratulations with your first 3D print on the FELIX Pro 1.
10.1 Remove the 3d printed object
When the print-job is
finished the display will
indicate that the 3D printer is
cooling down.
To remove large objects
(larger than about
100x100mm) it is
recommended to take off the
print bed.
Before removing the object it
is recommended to let the
bed cool down to 30°C.
NOTE: Make sure the heated
bed is not heating, when
removing the bed!!