Register your Passport Event Series 2 online at start.fender.com.
SYSTEM SETUP
1. OPEN: Flip open cabinet latches on top of Passport and detach speaker cabinets from powered mixer section:
2. PLACEMENT: For optimal results, elevate speaker cabinets on Passport speaker stands or sturdy tables. Place
the speakers far apart to maximize stereo separation. Position mixer close by for easy access to control panel:
3. SPEAKER CABLE/POWER CORD STORAGE: Open storage compartment on rear of mixer and remove power
cord and speaker cables:
4. POWER CORD/SPEAKER CABLE CONNECTION: Plug speaker cables into left and right speaker jacks on back
of the mixer (upper right arrow), then connect corresponding left and right speakers. Make sure power switch is off
before connecting power cord (included) into power inlet on back of mixer (lower left arrow); plug other end into a
To Next Page
Loading...
