K. PAIR BLUETOOTH: Press for Bluetooth pairing with external devices. When button is flashing blue, select
“PASSPORT EVENT” in external device Bluetooth menu. Button will stop flashing and illuminate blue continuously
when connection is successful. Press and hold button to disconnect Bluetooth. For best sound quality, set volume
control on external device (i.e., smart phone) to 75-100 percent of its maximum level.
L. 1/4″ LEFT (MONO)/RIGHT INPUT: Inputs for line-level stereo audio sources requiring separate 1/4″ jacks for
each channel. Using stereo L/MONO jack by itself functions as mono channel; mono output will be heard from both
speakers.
M. 1/8″ STEREO INPUT: Input for mobile devices, computers and other line-level stereo audio sources with 1/8″
connection.
N. HEADPHONE OUTPUT: Connect headphones and recording equipment here. Individual channel controls affect
this output; MASTER VOLUME (A) does not.
O. LEVEL CONTROL: Adjusts HEADPHONE OUTPUT (N) and MONO OUTPUT (P) signal levels.
P. MONO OUTPUT: For connection to a powered monitor. Signal level is pre-MASTER VOLUME (A); can be
adjusted using LEVEL CONTROL (O).
Q. SUB OUTPUT: For connection to a powered subwoofer. Set subwoofer crossover frequency control to 120Hz.
Use subwoofer’s volume or level control to set bass level to preference. External subwoofer use automatically
removes signals below 120Hz from main Passport amp and speakers.
R. POWER/PROTECT LEDS: POWER LED illuminates green when system is on. Passport features internal
protection measures that will shut down audio output in the event of electrical or thermal problems; PROTECT LED
will illuminate red when this happens. Passport will automatically reset itself on resolution of such problems. If
Passport does not reset automatically, check fuse in power cord socket on rear panel (O). If PROTECT LED remains
illuminated after unit has had sufficient cooling time and other power outlets have been tried, consult an authorized
Fender Service Center.
REAR PANEL
S. VOLTAGE SELECTOR: Change the setting of this 100V/120V220V/240V switch only when using Passport in a
country that requires a different voltage setting.
T. POWER: Turns Passport on and off.
U. POWER CORD SOCKET/FUSE: Connect power cord (included) to this socket; plug other end into a grounded AC
outlet in accordance with correct VOLTAGE SELECTOR (S) setting. To check/replace fuse, unplug power cord and
pry fuse holder from POWER CORD SOCKET; replace fuse only with another of the same type and rating.
V. SPEAKER OUTPUTS: Connect Passport speaker cables (included) here.
SPECIFICATIONS
To Next Page
Loading...
