1.3.7 General information
When parking, park the machine on a solid level
surface and lower the header to the ground. Put all
controls in neutral, center and lock the steering
wheel, and apply the parking brake. Stop the
engine and take the key with you.
WARNING: Whole body crushing
hazard. A loss of hydraulic pressure or
movement of the mechanism can
cause the raised machine component
to fall.
Personal injury or death can occur.
Install the lift cylinder stops before
working on the machine to prevent
movement.
Make sure the machine is in the proper operating
condition according to the Operator Manual.
Always operate the machine with the control
console turned on.
Do not dismount from moving machinery.
Stay o slopes too steep for operation.
Be aware of the size of the machine and have
enough space available to allow for operation.
GUID-E77631FB-0DC0-4637-9090-88018315176E-high.jpg [High]
Fig. 20
Pay special attention because some activated
devices (open grain tank extensions, open grain
unloading auger, fully raised header, etc.) may
aect the stability of the machine.
Do not use the machine in the following situations:
• When the maximum slope of the ground
exceeds the maximum slope limit of the
machine.
• If the correct tire pressures and correct
operation of the levelling system (if equipped)
has not been verified.
• If the ground is not firm or has sudden contour
changes.
• The tires do not have sucient traction on the
ground.
• Close to the edge of ditches or steep drops.
Stay o slopes too steep for operation. Keep the
header as low as possible while going down hills.
Never suddenly reverse the wheels to stop or back
up.
Where possible avoid operating the machine near
ditches, embankments, and holes. Reduce ground
speed when operating on rough, slippery, or
muddy surfaces and when turning or crossing
slopes.
GUID-D5F08D55-46E8-4823-8DBF-6C78DDF4387E-high.jpg [High]
Fig. 21
GUID-37023B41-C0ED-4F86-A909-1F42C1FE5D97 [V4]
1. General
IDEAL Series Combine 1-19
79037318C
To Next Page
Loading...
Need help?
General
