On these combines a noise level of 80 dB (A) is exceeded only if the combines are operated with doors
open.
In such situations, it is recommend to wear hearing protectors as specified by national law.
Noise levels are shown in the table below.
Ambient noise during movement - Directive 2009/63/EC.
Ambient noise levels are shown in the table below:
Engine Sound pressure level LpA (dB) in the
cab
Ambient noise in motion dB (A)
Directive 2009/63/EC
All engines 76
[1]
88
[1]
Uncertainties surrounding 2dB (A)
1.3.41 Vibrations in the cab
In accordance with European Directives 2002/44/EC and 2006/42/EC and further updates, the vibration
levels to which the operator's body (in his seat) is exposed are listed below, using the most appropriate
measuring methods for the machine in operation.
The vibration levels are measured three-dimensionally at the operator seat in accordance with the ISO
5008 standard.
The values below refer to the mean weighted square value in frequency (Bw in m/s2).
Longitudinal
Acceleration
Transverse Acceleration Vertical Acceleration
Trunk area of body
Bw <0.5 Bw <0.5 Bw <0.5
Arm-hand
Bw <2.5 Bw <2.5 Bw <2.5
Measurements were made under normal working conditions; the operator's seat complies with Directive
78/764/EC and further updates.
NOTE:
Other factors that are independent of the machine, such as driving behavior, management, operator's
physical condition and working environment all play an important role.
For additional information and/or suggestions for reducing vibrations, please consult CEMA's Practical User
Guide (www.cema-agri.org).
1.3.42 Electromagnetic emissions
(2014 / 30 / EC Directive)
All electric components of the machine emit an electromagnetic field that varies depending on component
features.
Since all situations that may arise in practice cannot be defined in advance, a maximum permissible limit
has been set for electromagnetic emissions.
The purpose is to prevent interference and/or damage to the machine control systems.
IMPORTANT:
1. Any additional equipment installed on the machine which is not built by AGCO must bear the CE mark.
2. The max. power (Watt) of the additional equipment must not exceed the limits set by the national
authorities.
3. The electromagnetic field emitted by the electronic components of the machine must not exceed the
max. limit of 24 V/m.
GUID-779E422D-2EF2-4971-8139-38F96E9351C0 [V1]
GUID-03A0639B-AE36-4BC1-9AE7-F24DA54F312A [V1]
1. General
1-56 IDEAL Series Combine
79037318C
To Next Page
Loading...
Need help?
General
