Need help?Do you have a question about the FENDT Vario 724 and is the answer not in the manual?
General| Engine Power | 240 hp |
|---|---|
| Max Speed | 50 km/h |
| Fuel Tank Capacity | 400 liters |
| Rated engine speed | 2100 rpm |
| Tire Size (Front) | 540/65 R30 |
| Tire Size (Rear) | 650/65 R42 |
| Transmission | Vario |
| Hydraulic System | Load-Sensing |
| Engine Type | 6-cylinder |
Details electrical safety precautions for equipment installation, emphasizing correct polarity and connection order.
Instructions for preparing the machine and installation site before beginning the SmarTrax MD system setup.
Best practices for installing or operating the SmarTrax MD system for the first time or when moving it to another machine.
Clarifies the assumed perspective for following installation instructions: standing behind the machine, facing the cab.
Information on where to find software and manual updates for the Raven Applied Technology products.
Lists components included in the SmarTrax MD installation kit, advising users to compare items with the list.
Detailed steps for safely removing the steering wheel from the machine's steering column.
Instructions for installing the anti-rotation bracket onto the steering column, including removing covers and clamps.
Steps to install the female spline adapter, steering wheel nut, and ring gear onto the steering column stem.
Procedure for aligning and reinstalling the steering wheel onto the steering column and securing it.
Guidance on installing the mechanical drive unit, potentially involving an anti-rotation pin.
Criteria and points to consider when selecting the optimal mounting location for the SmarTrax MD node inside the machine's cab.
Instructions for assembling and mounting the node bracket and installing the SmarTrax MD node for Vario 700 & 800 Series.
Steps for selecting a location and securely installing the foot switch in the machine's cab floor.
Procedure for connecting the node harness to the SmarTrax MD node, foot switch, and operator presence switch.
Instructions for installing the chassis power cable when the machine lacks an existing power system.
Steps for connecting the SmarTrax MD system to an existing CAN system via an interface tee cable.
To Next Page
