Fenix E05R User Manual

FenixE05RFlashlight

TechnicalParameters 
ANSI/PLATOFL1
Burst High Med Low

Output
400lumens 150lumens 25lumens 3lumens

Runtime
/ 55minutes* 5hours 30hours

Distance
64meters 40meters 17meters 8meters

Intensity
1046candela 412candela 72candela 15candela

ImpactResistance
1meter

Submersible
IP68
Note:Accordingto the ANSI/PLATOFL1 standard,theabovespecificationsare fromtheresults
produced by Fenixthrough its laboratory testing using the built‐in 320mAh Li‐polymer battery
underthetemperatureof21±3°Candhumidityof50%‐80%.Thetrueperformanceofthisproduct
mayvaryaccordingtodifferentworkingenvironments.
*The High output is measured in a total of runtime including output at reduced levels due to
temperatureorprotectionmechanisminthedesign.

ProductFeatures 
 400lumensmaximumoutput,64metersmaximumbeamdistance.

Fenix E05R Specifications

General

Lumens	300
Water Resistance	IP68
Impact Resistance	1 meter
Switch Type	Tail switch
Modes	Low, Medium, High
Material	Aluminum
Battery Type	Li-ion battery (included)

Summary

Technical Parameters

Operating Instructions

On/Off

Press and hold the side switch for 0.5 seconds to turn the light on or off.

Output Selection

Single click the side switch to cycle through Low, Medium, and High output modes.

Instant Burst

Press and hold the side switch for 1.2 seconds to enter instant Burst mode.

Lock/Unlock

Double click the switch within 0.5 seconds to lock or unlock the light.

Charging

Intelligent Overheat Protection

Usage and Maintenance

Warning