EasyManua.ls Logo

Fenix PD35TAC - Main Features; Operation Instruction; Mode Switching; Tactical Mode

Fenix PD35TAC
5 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
*Due to the protective setup of automatically turning to High from Turbo after working 5
minutes, the runtime of the Turbo brightness level is the accumulated time.
Main Features
Uses Cree XP-L (V5) LED with a lifespan of 50,000 hours
Powered by one 18650 rechargeable Li-ion battery or two 3V CR123A Li-ion batteries
137mm (length) x 25.4mm (diameter)
89-gram weight (excluding battery)
Tactical tail switch, momentary-on function
Stainless side switch to select output mode under Outdoor mode
Side switch only capable of mode changing under Tactical mode
Digitally regulated output maintains constant brightness
Low-voltage reminder indicates when battery replacement is needed
Reverse polarity protection, to protect from improper battery installation
Anti-roll, slip-resistant body design
Made of durable aircraft-grade aluminum
Premium type III hard-anodized anti-abrasive finish
Toughened ultra-clear glass lens with anti-reflective coating
Operation Instruction
Mode Switching
When the light is on, long press on the side switch for 3 seconds till the LED flashes twice at
Low output, and then to cycle through Tactical Mode Outdoor Mode.
Tactical Mode
ON/OFF
Fully press on the tail switch to turn on the light, press once again to turn it off
Output Selection
Slightly click the tail switch to turn the light on temporarily, release it the light will go out, click
the tail switch again the light will cycle through Turbo Strobe Low.
Continue to fully press on the tail switch after selecting the needed output mode, the light will
last on present output mode
Notice: 1. Under this mode, Turbo mode is defaulted when the light turned on
2. Under this mode, the side switch only works on mode changing
Outdoor Mode
ON/OFF
Slightly click the tail switch to turn the light on temporarily, release it the light will go out
Fully press on the tail switch to turn on the light, press once again to turn it off
Output Selection
With the light on, single-click the side switch to cycle through EcoLowMidHighTurbo.

Related product manuals