32
7. USE AND FUNCTIONALITY OF THE HEATER
7.1 ADVICE AND CAUTIONS
• Before turning the device on, make sure that there is no ammable material inside or near the heater that could enter the
combustion process.
• Use fuel that is recommended by the manufacturer.
• Do not use the unit as an incinerator or for any other use apart from the use for which it has been designed.
• The external surfaces of the heater, especially the glass, reach high temperatures when touched, meaning that it is
necessary to take the proper precautions to avoid burns.
• Consult this instruction manual if you are uncertain about any point. Do not manipulate the display until you are sure which
procedure you must follow.
• Pay special attention to the alarms and messages that are shown on the display. It is even recommended to make a note
of them, which will make the work of the Technical Support Service easier in the event that they are involved.
• Before turning on the heater, make sure that: nothing is obstructing the air inlet pipe, the burner is properly positioned and
clean, the ashtray is in place, and the front door that provides access to the combustion chamber is properly closed. The
door must only be opened when the heater is stopped and cold.
• It is absolutely forbidden to remove the protective grille that is located in the tank.
• Do not touch the heater with wet hands because it is an electrical device.
During operation, the unit experiences considerable expansion in the process of heating and
cooling, which means that it is absolutely normal to hear clicking sounds made by the steel frame.
Under no circumstances can this be considered to be a defect of the unit.
7.2 FIRST LIGHTING
I. Make sure that the heater is properly connected to the mains power supply.
II. Following this, turn on the general switch on the heater, which is located on the rear part of the heater next to the
connection for the cold air intake.
III. After this, the time sill appear on the upper display (D1) and the temperature on the lower display (D3).
IV. At this time, the error Er11 could also appear on the display, which means that the time and date are not updated,
which can occur after a long period of not being connected to a mains power supply. See chapter 9 `ERRORS AND
SOLUTIONS´ in order to nd out how to continue, because if there is an error on the screen, the unit cannot be properly
started up.
V. To turn on the heater, hold the (P1) button pressed down until a beep is heard. At this point, the display will show
the following.
To Next Page
Loading...
