35
7.3.7 RECOVERY OF THE IGNITION (`REC´)
This stage cuses the heater to turn itself o whilst the word `rEc´ will appear in ashing letters on the upper display.
When the turning-o process concludes, the heater will automatically turn itself on.
The heater can enter this stage due to the following reasons:
• If during the process of turning the heater o (`OFF´), the user pushes the ON/OFF button again to turn it back on.
• If the heater is in a normal operation stage and a power cut occurs in the mains power supply and if the heater is
still hot when the mains power supply comes back online.
8. MAINTENANCE AND CLEANING
It is necessary to carry out certain maintenance tasks in order to keep the heater functioning properly. The frequency of
these maintenance tasks will depend largely on the hours of operation and the quality of the fuel that is being burned. Some
of these maintenance tasks must be carried out daily and others can be carried out on a seasonal basis.
A table of the tasks that require carrying out is shown below:
TAREAS
DAILY
WEEKLY
MONTHLY
ANNUAL
USER
TECHNICIAN
Cleaning the brazier, cleaning the holes in the brazier, and removing ashes
Removal of ashes from the burner
Use of the scrapers
Empty ashtray and vacuum the grate and housing
Clean the inspection ‘T’
Extraordinary cleaning
AN ASH VACUUM CLEANER IS REQUIRED TO CLEAN THE HEATER
To Next Page
Loading...
