Ferno 35A - Safety and Instruction Labels

5
© Ferno-Washington, Inc 234-3451-01 February 2011
Model 35A Series
1.6 Safety and Instruction Labels
Safety and instruction labels place important information from the users’ manual on the cot. Read and follow label instructions. Replace
worn or damaged labels immediately. New labels are available from EMSAR (page 29) or from your Ferno distributor (page 2).
Safety Information
Pinch Point Label (Qty. 4 or 6)
Keep hands clear of these areas
Tray Label (Qty. 2)
On cots equipped with a lower storage tray, this label
reminds operators to empty the tray before lowering or
loading the cot.
Hand Guard Label (Qty. 2)
Removing the guard can expose operators or helpers to injury. Do not
remove the guard.
General Information Label (Qty. 1)
is label identies the cot and warns the user to read the users’
manual, operate the cot with two trained operators, and to observe the
cot load limit.