16
4 INSTRUCTIONS FOR INSTALLATION – HANDLING - PARKING
4.1 Lifting and unloading
To handle the flail hedge mower, use a hoist or a crane with lifting capability
suitable to the weight of the machine (see TAB. 1) and with proper chains and type
approved hooks to be fixed in the marked points, as shown in FIG. 13. This can be
done with a lift truck, first close the arms and fix them to the frame with a chain.
4.2 Unpacking
- In order to transport it, the mower can be supplied in a special pack (disassembled
and on pallets).
In this case, a card showing the reassembling procedure will be attached to the Use
and Maintenance manual.
4.3 Attachment to and detachment from the tractor
Before carrying out this operation and any time the machine is used, it is mandatory
to:
- Visually check the machine in general
- Check that all guards are fitted and in good condition
- Confirm that all flails are fitted and in good condition
- Grease the bearings and any other parts as indicated by a decal (FIG. 42)
To Next Page
Loading...