ferrum HYPSOS - Firmware Update Procedure

Please check our website to check if there is a new firmware version available.
You can check your currently installed firmware in the Ferrum HYPSOS Firmware Loader app.
Windows
Please download the Ferrum HYPSOS Firmware Loader app from this website: www.ferrum.audio/support
and install it on your computer.
Turn o the HYPSOS by using the main ON/OFF switch (Fig. 2D) then disconnect HYPSOS DC output
cable.
Connect HYPSOS via USB cable to your computer.
Press the knob and when holding turn on HYPSOS using the main ON/OFF switch.
Open Ferrum Firmware Updater app and open firmware file for HYPSOS - firmware file is available on our
website here: www.ferrum.audio/support
Click on the “Flash device” button - the process of update will begin.
When the update process is complete, turn o the HYPSOS using the main ON/OFF switch (Fig. 2D), wait
5 seconds and you're done. You can use the HYPSOS again.
14
user’s manual
HYPSOS by Ferrum
6. FIRMWARE UPDATE
1.
2.
3.
4.
5.
6.
7.