14
Working with the machine
On/Off switch [1-2]
Pressing only the switch
[1-2]
does not start the
machine –
it is not a machine fault
!
Upon screwing to the required depth, the power
tool switches off!
The machine can be switched on by means of sev-
eral methods:
a)
Set the forward / reverse switch
[1-3]
into ma-
chine clockwise operation.
Set the switch
[1-4]
into MAN position.
In order to switch on the power tool, apply the
switch
[1-2]
and concurrently press the bit on
the screw.
Use the switch
[1-2]
to gradually regulate the
speed.
b)
Set the forward / reverse switch
[1-3]
into ma-
chine clockwise operation.
Set the switch
[1-4]
into AUTO position.
Press the bit on the screw and the power tool
will switch on.
Switch
[1-2]
does not need to be pressed. Maxi-
mum speed is set automatically.
c)
Set the forward / reverse switch
[1-3]
into ma-
chine anti-clockwise operation.
In order to start the power tool, press the switch
[1-2]
.
The switch MAN/AUTO
[1-4]
is in any position.
Use the switch
[1-2]
to gradually regulate the
speed.
If the forward / reverse switch
[1-3]
is set to
anti-clockwise operation, the screwdriver can
be started only by pressing the switch
[1-2]
without additional pressure on the bit!
It is not necessary to remove the depth stop in
order to unscrew screws!
Depth stop
Turning the depth stop
[6-1]
sets the screwing
depth – see figure
[6]
. The setting accuracy is ap-
prox ± 0.1 mm.
Upon setting the depth, set some screws to test and
adjust the depth.
Depth stop assembly
Fit the depth stop
[7-1]
on the gear box
[7-2]
.
Press until it engages in the groove.
To Next Page
Loading...
