109Capron - 04-17 - CAP-0017-01EN
Sanitary fittings
11
Position the vehicle horizontally.
Switch on the 12 V power supply on the panel.
Close the safety/drainage valve. Turn the knob (Fig. 97,1) perpendicular to
the safety/drainage valve and push the push button (Fig. 97,2) in. The
closed safety/drainage valve is shown in Fig. 98.
If the temperature is below 6 °C, the safety/drainage valve cannot be
closed.
Close all water taps.
Close the drainage opening of the water tank.
Open the drinking water filler neck on the outside of the vehicle.
Fill the water tank with drinking water. Use a water hose, a water canister
with a funnel or similar for filling.
Set all the water taps to "Hot" and open them. The water pump is turned
on. The warm water pipes are filled with water.
Keep the water taps open until the water flowing out of the water taps has
no bubbles in it. This is the only way to ensure that the boiler is full of water.
Set all water taps to "Cold" and leave them open. This will fill the cold water
pipes with water.
Keep the water taps open until the water flowing out of the water taps has
no bubbles in it.
Close all water taps.
Close drinking water filler neck.
Check that the cap on the water tank is not leaking.
11.2.3 Topping up the water
To fill the water tank with drinking water, proceed as follows:
Open drinking water filler neck (Fig. 96).
Fill the water tank with drinking water. Use a water hose, a water canister
with a funnel or similar for filling.
Close drinking water filler neck.
Fig. 97 Safety/drainage valve open Fig. 98 Safety/drainage valve closed
X When filling the water tank, observe the maximum permissible gross
weight of the vehicle. Luggage must be reduced accordingly when the
water tank is full.
To Next Page
Loading...
